Adding/Removing Devices and Sensors

Aaron
Updated:

You can pair Everysight Raptor with the Raptor controller and additional BLE and/or ANT+ enabled sensors, like a heart rate monitor, power meter, and speed/cadence sensors, to give you deeper insight into your rides.

ANT_-01-01-01.png Standard__HR_ANTDeviceProfile.png Standard__SPD_bike_ANTDeviceProfile.png Standard__SandC_ANTDeviceProfile.png Standard__CAD_ANTDeviceProfile.png Standard__PWR_ANTDeviceProfile.png

Adding Devices & Sensors

Adding Devices & Sensors

1. On your Raptor smartglasses main menu, navigate by swiping the touchpad to Settings. Tap to select.
   
2. Once in the Settings menu, navigate to Sensors and Devices. Tap to select. 
   
3. Once in the Sensors and Devices menu, navigate to the device or sensor you want to connect. Tap the device or sensor type to begin a scan.
   
4. Swipe until you see your device. Bluetooth will be represented by a name, ANT+ will be represented by a number only. Tap on the desired sensor to pair it with your Raptor.
   

 5. Once connected, you will be returned to the Sensors and Devices menu and the device or sensor you are connected with will be highlighted in green.

 Removing Sensors or Devices
Removing Sensors or Devices

1. On your Raptor smartglasses main menu, navigate by swiping the touchpad to Settings. Tap to select.
   
2. Once in the Settings menu, navigate to Sensors and Devices. Tap to select. 
   
3. To remove a sensor or device, simply rotate the carousel until the desired sensor is centered and its label appears.
   
4. Swipe up to disconnect from the selected device. Swipe_UP.GIF